How to Overcome a Dead Motor Hit by Water, Here’s the First Handling

–

How to deal with a dead motor hit by water will be a solution for its users. One of the causes of sudden death, is due to several unintentional events, such as the vehicle being submerged in water for a long time.

Things like this will be dangerous, especially if there is a certain type of water. For example, salt water, which if it enters the contents of the motor components will certainly have more severe consequences.

Baca Juga : Motor Matic Tidak Bisa Distarter, Kenali Apa Penyebabnya

Therefore, if this happens, whether it is fresh water with mud, or salt water in the sea, we must immediately deal with it.

This is so that nothing worse happens in the future. Because, faster handling will reduce the potential for engine damage.

Here’s How to Overcome a Dead Motor Hit by Water

If your motorbike or vehicle is exposed to water for a long time, even to death, then try to do some of these tips. This reference will be a safe solution and not aggravating the damage of course.

Remove the Water

The first step is to remove the water that is still in the motor. Try not to turn on the motor, if the water has not completely disappeared from the vehicle.

Motorcycles are usually submerged in water in the event of a flood. It could also be because we choose to park in the open and make it rain for a long time, of course this will be dangerous.

If we are still determined to turn on the vehicle, it will damage other components too. For example, previously only a few parts were damaged, it will become more severe and widespread the damage.

The key to how to deal with a motor that dies in water, is not to turn it on first. The goal is to prevent water from spreading to other components that are risky and easily damaged.

Ensure Cop and Iron Cable

The next way to deal with a dead motor is to check the condition of the cop and spark plug wires. The motor has a place to store the spark plug and has a low point.

Because it is located next to the engine block of the motor, the location is easy to get splashed with water, and even submerged which creates a risk.

Baca Juga : Penyebab Motor Matic Tidak Kuat Nanjak Karena Tenaga Berkurang

While the rubber plugs that are exposed to water tend to wear out easily. Therefore, when the hot temperature is exposed to water, the molecules will decompose.

Therefore, always check the caps as well as cables and spark plugs, especially in conditions that have the potential to be exposed to water. For example, the rainy season, or a trip to a flooded area.

Check Carburetor

The way to deal with a dead motor in contact with water on this one is by disassembling it to make sure. Before disassembling, close the gas line valve from the tank to the engine carburetor.

After that, turn the bolt for exhaust counterclockwise. If the gasoline has come out, then we can open the channel, turn the bolt back until it reaches the maximum and strong point. The operation of this carburetor engine is very important in running your motor.

Exhaust

Next we can check the condition of the exhaust which is the exhaust channel for gas on the motor. Use the center standard to open the exhaust and remove the water contained in it.

Block so that the position of the rear motor is lower and the water will come out smoothly. Make sure our exhaust provides additional oil so that it is not exposed to corrosion.

Heating Machine

The last way to deal with a dead motor is to start the engine. We have to do this so that the engine is warm and hot again.

Just like doing motor maintenance, we have to warm up regularly. So that the condition of the vehicle is always prime and fine.

Therefore, we should always perform regular service. So if something happens that we don’t want, we can still handle it well.

The death of the vehicle, especially this motorbike, can also be handled easily. You can try to do the first treatment like the tips above.

But if you don’t have the skills, you should take it directly to the workshop. This is to avoid mishandling and even adding to the damage to other components.

So, has your favorite vehicle ever experienced this one? Are you right on the first treatment?

How to deal with a dead motor hit by water, which we discussed in full, hopefully it can help your problem. So good luck trying these tips! (R10/HR-Online)

Editor: Adi Karyanto

–