Skip to main content
World Today News
  • Home
  • News
  • World
  • Sport
  • Entertainment
  • Business
  • Health
  • Technology
Menu
  • Home
  • News
  • World
  • Sport
  • Entertainment
  • Business
  • Health
  • Technology
Sources, Union Dispute FAA Oversight of Contractor Router Replacement

Sources, Union Dispute FAA Oversight of Contractor Router Replacement

November 19, 2026 Newsroom News

The Federal Aviation Administration exercised little direct oversight of a contractor’s router replacement that triggered the nationwide ground stop on November 13, according to sources and the union representing FAA technicians, CNN reported — a claim the agency’s own spokesman now appears to contradict.

The dispute over who watched the L3Harris engineer work sits at the center of an investigation into the longest halt of US flights since September 11, 2001. Roughly 3,500 aircraft were airborne when the FAA ordered all departures frozen for more than four hours on Friday, November 13, while technicians hunted a flood of data that had overwhelmed the aging network.

Federal Aviation Administration Administrator Bryan Bedford has said the L3Harris engineer who performed the update “was supervised by an FAA technician” and that a risk assessment was done beforehand. Sources who spoke to CNN, and the Professional Aviation Safety Specialists union, tell a different story.

“There was no supervision,” one source told CNN. Another said the technician “was only there to open the door.”

The escort who was told to stand aside

On the morning of the ground stop, an FAA technician accompanied a private L3Harris contractor to a remote radio-communications facility in southern Arkansas that serves air traffic control centers, to replace a decades-old router. The technician considered his job finished once the contractor entered the building, according to two sources familiar with the room and to the union, CNN reported.

Sources, Union Dispute FAA Oversight of Contractor Router Replacement
Photo: Los Angeles Times

Elizabeth Doherty, a spokesperson for the Professional Aviation Safety Specialists union, told CNN that the technician’s instructions were “simply to allow the contractor access to the building,” that he had “no instructions to assist or collaborate in any way,” and that no PASS-represented employee was asked to perform a risk assessment for that particular upgrade.

Bedford, at a Tuesday press conference, described the contractor as “a certified, highly trained engineer, an ex-Air Force veteran” who was doing work he had done dozens of times.

FAA spokesperson Hannah Walden told CNN by phone that the agency was still gathering information. “It may have been a misunderstanding or something else,” she said, adding that the agency was not asserting either version at this point.

After CNN’s article published, Walden issued a statement that appeared to contradict Bedford. “The FAA escort is responsible for facilitating the L3Harris technician’s access to the building and his exit. Since this is L3 equipment, the escort is not present while the technician performs his work,” she said in the statement.

A March 2025 memo changed the rules

In a memo dated March 2025, the FAA detailed changes to how maintenance and upgrade work is executed, writing that it is “critical to approve without delay maintenance performed by telecommunications providers,” CNN reported.

Sources, Union Dispute FAA Oversight of Contractor Router Replacement
Photo: World Socialist Web Site

CNN’s sources attributed the change to two pressures: a chronic, years-long shortage of FAA technicians, and the administration’s push to accelerate modernization of the air traffic control system using $12.5 billion from the “big and beautiful bill” of President Donald Trump.

How the November 13 outage unfolded

L3Harris notified the FAA on November 9 that it intended to replace a router at the agency’s remote facility in El Dorado, Arkansas, with work scheduled to begin at 9:00 a.m. on Friday, November 13, according to one source.

Neither was the L3Harris engineer’s conduct after the job clear: a former FAA technician told CNN that checking with controllers before leaving a site is standard practice — “every time I was out there… I would call the TRACON, the center or the tower… and say: ‘I’m getting ready to leave. Is everything looking good?'” — but it is not known whether the L3Harris engineer followed that procedure.

The new router set off a cascade of communication failures, saturating the FAA’s aging network with data. The agency later described an “excess of data” hitting the system at a rate of 1,000 connection attempts every 4 to 5 seconds, destabilizing aircraft communications and radar signals across 17 of the country’s 22 regional air traffic control centers. The halt was not lifted until 8:15 p.m., more than four hours after it began.

Sources, Union Dispute FAA Oversight of Contractor Router Replacement
Photo: Telemundo Miami

Washington splits over who is to blame

Transportation Secretary Sean Duffy blasted L3Harris the day after the stop. “We need L3Harris, or whoever supplied us that router, to do a better job,” he said at his Saturday press conference. Period.”

By Tuesday, Bedford had struck a different tone about the same company, calling the engineer who replaced the router generally competent. Duffy, for his part, said on the streaming platform 2WAY’s “The Morning Meeting” that the stop could have ended sooner if L3Harris had identified and isolated the problem faster — a detail reported by the Associated Press.

President Donald Trump, who stayed silent on the stop until Sunday, blamed aging technology and Democrats, particularly his predecessor Joe Biden, when he spoke to reporters on Monday while leaving the White House, according to Los Angeles Times. “The only thing in terms of taking responsibility is that, for 40 years, they should have done this,” Trump said.

Several key legislators said Tuesday that approving the full amount is unlikely right now, according to the Associated Press. Democrats on the Senate Commerce Committee said they believe only 400 of more than 3,600 new routers have been installed, and asked in a letter that installation stop until the root cause of the failure is identified.

The FAA, meanwhile, has paused installation of the routers linked to the outage and shut down the Juniper routers already in place. The agency is relying on older Cisco routers — some in service for about 25 years — to keep the network running, while the failed equipment is analyzed in a lab at L3Harris’s headquarters.

Duffy acknowledged Tuesday that investigators have replicated the failure but have not resolved the underlying cause, including whether a cyberattack played any role.

Federal network operated by private company

The incident exposes the complications of a communications system operated by the federal government but owned by a private company. The FAA handed its telecommunications network to Harris Corporation in 2002, according to the World Socialist Web Site; Harris later became L3Harris as part of a merger, and that company has operated and maintained the FAA’s network for decades.

A 2009 outage that affected 820 flights was caused by a Harris technician who configured a router incorrectly, the Transportation Department’s inspector general found — circumstances the AP noted resemble last week’s failure.

L3Harris declined to answer CNN’s questions in detail. In a statement, the company said it is “collaborating with the FAA in its investigation to understand the conditions that led to the national air traffic ground stop on November 13.”

Travelers scrambling through the fallout — rebooked flights, canceled plans just two weeks before the holiday season begins, disrupted airports from Dulles to smaller fields — have been left to sort out the practical mess themselves while the investigation continues in Washington.

L3Harris Technologies, the contractor at the center of the dispute, was formed in June 2019 from the merger of L3 Technologies and Harris Corporation, a combination that made it the sixth-largest defense contractor in the United States.

Its roots stretch back to 1895, when the Harris Automatic Press Company was founded in Niles, Ohio, as a maker of printing presses before pivoting into electronics during the space race. Headquartered in Melbourne, Florida, the company produces everything from tactical radios and avionics to night vision equipment, and has long been one of the top ten US government contractors.

The open question is now a matter of record: the FAA’s own spokespeople have given two different accounts of whether anyone was watching the contractor work, and the agency says it is still gathering information. What remains unclear, as of Wednesday, is how closely the L3Harris engineer was actually supervised at the remote facility — and whether the March 2025 memo will survive the scrutiny now coming from Congress.

More on this story: US Flight Grounding Caused by Fiber Upgrade, Officials Say · Aging Air Traffic Control Systems and Outdated Technology Cause Massive Flight Disruptions

Share this:

  • Share on Facebook (Opens in new window) Facebook
  • Share on X (Opens in new window) X

Worth a look

  • Driver Pleads No Contest to Reduced Charge in Fatal Woodstock Crash
  • Dutch Senate Approves Alcohol Ankle Bracelet Law and Immediate Driving Bans During Appeal
  • Nvidia Board Hires Heidrick & Struggles to Find CEO Replacement; Arm’s Haas Among Candidates, Guardian Reports (newsy-today.com)

Related

Search:

World Today News

World Today News is your trusted source for global journalism — breaking headlines, in-depth analysis, and reporting from around the world.

Quick Links

  • Privacy Policy
  • About Us
  • Accessibility statement
  • California Privacy Notice (CCPA/CPRA)
  • Contact
  • Cookie Policy
  • Disclaimer
  • DMCA Policy
  • Do not sell my info
  • EDITORIAL TEAM
  • Terms & Conditions

Browse by Location

  • GB
  • NZ
  • US

Connect With Us

© 2026 World Today News. All rights reserved. Your trusted global news source directory.
For contact, advertising, copyright, issues email: [email protected]

Privacy Policy Terms of Service